Eton E100 owner manual BASIC RADIO OPERATION continued, Volume And Tone Controls

Models: E100

1 41
Download 41 pages 51.33 Kb
Page 11
Image 11
5 BASIC RADIO OPERATION continued

E100 OWNER’S MANUAL

5 BASIC RADIO OPERATION continued

VOLUME AND TONE CONTROLS

The volume control (23), labeled VOLUME, is located on the right side of the radio. To change the volume, rotate the volume control knob.

The tone control (22), on the right side of the radio is labeled LOW/HIGH. Use the position that you like best.

SELECTING FM, AM or SHORTWAVE

After turning on the E100, pressing the button labeled ‘FM/MW/SW Band’ (11), allows selection of FM, AM and SW. Note that when the AM band is selected, the display shows MW, not AM. The frequency digits (36) appear in the lower portion of the display.. The local sta- tions of the area that you are currently in will be heard on AM and FM. Shortwave stations from around the world will be heard on SW.

SETTING UP AM AND FM OUTSIDE OF NORTH AMERICA

You can skip this section if you are in North America and just purchased the E100. It is already set-up in the factory for use in North America. If you travel to other world regions, make the changes below as necessary.

Outside of North America, AM stations (MW in the E100’s display) are spaced in 9 KHz tuning steps. The FM frequency range may be different from that used in North America, e.g. like that used in Japan, 76-108MHz. To make these changes please see the instructions titled SYSTEM SET CODE TABLE, on pages 21-22.

9

Page 11
Image 11
Eton E100 owner manual BASIC RADIO OPERATION continued, Volume And Tone Controls, SELECTING FM, AM or SHORTWAVE