Eton E100 owner manual WORKING WITH MEMORY continued

E100 OWNER’S MANUAL

7 WORKING WITH MEMORY continued

2.Tune to the desired station.

3.Press/release the Mem.&Edit button (15). Note that the memory number digits (38) flash in the upper right corner of the display. The memory page number, P#, also appears, but does not flash.

4.Within 5 seconds use the numeric keypad to enter the memory number that you wish to store the station into (In the factory’s original memory setting, there are 25 memories per page. You would therefore enter a number between 01 and 25).

5.Within 5 seconds press the Mem.&Edit button, or wait 5 seconds.

After a few seconds, the upper right corner’s display returns to the clock.

SELECTING/CHANGING MEMORY PAGES

If you are not interested in changing memory pages and wish to keep the original factory memory page setting, skip this section.

At the factory, the E100 is set up to access memory page 1 when storing a frequency. You can leave this as-is or change to a differ- ent memory page. We suggest learning first to store stations into memory page 1 before changing to other pages. To do this, go to the previous section, STORING STATIONS INTO MEMORY. To change to the memory page, follow the directions below.

1.Press/hold the M.Scan/Page button (7) for about 3 seconds. Then release it. Note that the memory page (38) is flashing in the upper right corner of the display.

2.Within 5 seconds select the desired page with the Up/Hour and

14