HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the cyclonic dust cup, belt, and brush roll often.
To Change Dust Cup Pleated Filter:
NOTE: Turn off the switch and unplug the electrical cord before changing the Foam Filter. Never operate the vacuum cleaner without the dust cup or the pleated filter assembly.
1
|
Remove dust cup by pulling latch (1) forward, pivoting dust cup out and lifting up. To replace dust cup, put bottom of dust cup in place by aligning tabs in slots and pivot top assembly back into place. Push down on latch (1), making certain that latch securely snaps and overlaps tabs at top of dust cup.
Tabs
Slots
Check and clean the pleated filter once a month to maintain good performance. The filter can be cleaned by washing with mild detergent and warm water. Be sure pleated filter is completely dry before reinstalling.
To clean the Pleated Filter:
1.Grasp yellow filter frame and twist counter clockwise to remove.
2.Shake vigorously and brush off dust and lint.
3.If filter needs further cleaning, wash in warm water using a mild detergent.
4.Do not submerge gray dust cup lid, wipe only with a damp cloth.
5.When all parts are completely dry, replace filter on gray dust lid by twisting clockwise to snap and lock in place.
1
Gray Filter Assembly
2
Lint Trap
Cone
Use GENUINE EUREKA replacement pleated filter, 61805
10
