PRECAUCIONES ADICIONALES IMPORTANTES

DE SEGURIDAD (Cont.)

CARE & MAINTENANCE

1.Para evitar sobrecargar el circuito, no opere otro artefacto simultáneamente en

el mismo tomacorriente o circuito.

2.Si fuese absolutamente necesario utilizar un cordón de extensión, use uno calibre 14 de 15 amperios. Los cordones de menor capacidad se recalentarán. Debe tenerse cuidado al tender el cordón para no jalarlo ni tropezarse con él.

3.No deje el artefacto desatendido cuando esté enchufado a un tomacorriente.

CONSERVE ESTAS INSTRUCCIONES

SÓLO PARA USO DOMÉSTICO

ADVERTENCIA:

Este artefacto está equipado con un enchufe de 3 espigas y sólo puede enchufarse en un tomacorriente

de 3 orificios con conexión a tierra. Esta

es

una

medida de seguridad. Si el enchufe no encaja bien en el tomacorriente, contáctese con un electricista calificado para que cambie el tomacorriente. No intente burlar el dispositivo de seguridad de la tercera espiga para conexión a tierra del enchufe.

CUIDADO:

Siempre drene la condensación del agua de la manguera antes de usar la unidad si se ha dejado de usar por un largo rato. Para hacerlo, apunte la boquilla hacia un contenedor o lavadero y presione el gatillo del mango. Una vez que el agua se ha drenado, reinicie su uso normal. Nunca apunte la boquilla hacia las personas, animales o plantas.

If you consistently use demineralized or distilled water, cleaning the tank is unnecessary.

Rinsing out the steam cleaner: Normally, a periodic rinse of your Ultra Steam Shark will free it from deposits. This is recommended every 10-15 tankfulls, to free up any scale deposits from the tank.

Fill the boiler with water and shake the cleaner vigorously. Tilt the cleaner upside down to empty the boiler of water and any scale deposits.

Descaling your steam cleaner:

If the tap water in you area contains a high level of calcium deposits and you have been using tap water to do your steam cleaning, your should descale your unit after 10-15 tankfulls.

Step 1: Unplug the steam cleaner from the power source before you descale the boiler.

Step 2: Fill the boiler with 1 part (4 oz.) vinegar and 4 parts (16 oz.) water and leave overnight or for a period of approximately 8 hours. Do not screw the safety/filler cap onto the steam cleaner while you are descaling the boiler. Do not use the steam cleaner while descaling solution is inside the boiler.

Step 3: After the period of soaking, turn the steam cleaner upside down to empty solution from the boiler. Due to the fact that a small amount of solution will be left in the boiler, it is necessary to rinse the boiler out with clean water 2 or 3 times. Your steam cleaner is now ready for use.

Attaching the Shoulder Strap

Using the detachable shoulder strap allows for greater freedom of movement when both hands are needed for various cleaning tasks.

To attach the shoulder strap to the steam cleaner, simply snap the shoulder strap hooks onto the connecting rings on the unit body. See illustrations below.

Connection Points

When using the Ultra Steam Shark with the shoulder strap, avoid rocking or tilting the unit excessively as this may cause water to enter the hose and be discharged along with the steam.

15

12

Page 13
Image 13
Euro-Pro EP903 Precauciones Adicionales Importantes, DE Seguridad, Care & Maintenance, Descaling your steam cleaner