Page 12
Basic Maintenance
The Stand N Ride has been designed to provide years of
Due to the Stand N Ride’s modular design, there are virtually no user serviceable parts. Attempting to service or modify any of the scooter’s internal components may result in permanent damage to the scooter and will void the warranty. For service and repair, contact your nearest EV Rider dealer.
It is always best to check before each ride the condition of the cables, brakes and folding latches to ensure their proper settings and tightness.
Occasionally lubricate exposed latches, cables and fittings to keep proper function.
Trouble Shooting
Below are tips on how to handle technical situations that you may encounter:
PROBLEM |
| PROBABLE CAUSE(S) |
|
|
|
The key is turned to the ON position, but | 1. | The battery pack may not be fully engaged. Check that the floorboard and the top |
there is no drive. |
| of the battery pack are at level with each other. |
| 2. | The battery charge may be too low to drive and may need charging. |
|
|
|
The key is turned to the ON position, the | 1. | You probably have the charger plugged to the unit or to the unit and the wall. The |
batteries are fully charged and the brake |
| controller disables drive if it detects the charger connected to the unit. |
lever is not locked. |
|
|
|
|
|
The key is turned to the ON position, the | 1. | The brake may be engaged, which disables the controller. Depress and unlock the |
battery gauge shows charge, but there is |
| brake. |
no drive. |
|
|
|
|
|
The tiller/base frame coupler doesn't lock | 1. | The power connector is probably not aligned to allow for the tube to slide over the |
in place. |
| pin completely. Make sure that this is aligned and fully connected. |
|
|
|
The unit takes too long to brake and it | 1. | The brake needs adjusting. Rotate the brake cable adjuster away from the brake |
doesn't brake completely. |
| lever. |
|
|
|
The unit drives, but stops after a while. | 1. | The battery charge may be low. Charge the batteries until full charge is shown. |
| 2. | One of both of the batteries may be bad. Have the batteries tested with a load |
|
| tester to determine if they hold charge. |
|
|
|
The scooter drives, but suddenly stops | 1. | The batteries are probably low. |
during riding. | 2. | An over load current was detected by the controller. |
| 3. | Overheat condition detected by the controller |
|
|
|
