Chapter

3 OSD MENU SETUP

3

This chapter introduces how to change RS485 ID and Baud Rate and to configure the camera OSD menu.

STEPS

If you want to connect camera with keyboard or other RS-485 - controller, please refer to Section

3.2RS485 ID & Baud Rate setting. Otherwise, please go to STEP 2. Configure the camera, as described below:

3.1 Control Key General Operation Guide

Switch between Lens and Menu operation

Press and hold ( ~ 5 s) the joystick button for changing the operation mode of the joystick. Red LED: Menu mode, Green LED lens control mode.

Bring Up the General OSD Menu

Simply press the mini-joystick to bring up the general OSD menu.

Note: Make sure, that the joystick is in "MENU" mode (red LED under Joystick).

Navigate among the OSD Menu Items

Turn the mini-joystick up (c) or down (d) to move the cursor up or down.

Change Modes or Setting Parameters

Turn the mini-joystick left (e) or right (f) to adjust the mode or value of settings.

Switch to Sub-menu Screens

When an item with a sub-menu is selected, press inward on the mini-joystick to switch to the sub-menu for further settings. This may also be referred to in the instructions below as “pressing the setup button”. Please refer to the diagram below.

SETUP

EVERFOCUS

 

1. LENS

DC <┘

DC LENS

2. EXPOSURE

<┘

3. WHITE BAL.

AWB

fBRIGHTNESS +++++++++ 45

4. DAY NIGHT

EXT

5.

3DNR

ON<┘

RETURN RET <┘

6.

SPECIAL

<┘

 

7. ADJUST

<┘

Sub-Menu

8. RESET

<┘

9.

EXIT

Main Menu

 

 

 

16

Page 16
Image 16
EverFocus EZ610 manual Control Key General Operation Guide, Steps