MOTION CONTROL INSTRUCTION:
1. Press the switch on the console to switch the motion control function
on and off:
When the LED light is ON the MOTION CONTROL is active.
When the LED light is OFF the MOTION CONTROL is off.
2. After switching on the MOTION CONTROL wave your right hand
approximately 6 inches above the motion sensor on the right handle bar to
increase the speed. The sensor will sound one short BEEP per scan and
speed up by 0.1 MPH per BEEP. Holding your right hand approximately 6
inches above the right sensor constantly results in the sensor sounding one
long BEEP per second and speeding up by 0.5 MPH per BEEP.
3. Wave you left hand approximately 6 inches above the motion sensor on
the left handle bar to decrease the speed. The sensor will sound one short
BEEP per scan and decrease speed by 0.1 MPH. Holding your left hand
approximately 6 inches above the left sensor constantly results in the sensor
sounding one long BEEP per second and decreasing speed by 0.5 MPH per
BEEP.
4. Wave both hands approximately 6 inches above both motion sensors at
the same time. The sensor will sound two short BEEPs then stop the belt.
Always switch off the MOTION CONTROL function by pressing the switch
before turning off the power to the treadmill.
CONSOLE OPERATION
computer instructions
-27-
Use right senor to increase
speed.
Use left sensor to decrease
speed.
Use both sensors to stop
belt.