Exmark LAZER ZTM Lubrication Chart, Service Interval 40 hrs, Service Interval Refer to chart

Models: LAZER ZTM

1 48
Download 48 pages 48.19 Kb
Page 28
Image 28

5.1.10Check tire pressures:

Service Interval: 40 hrs.

a)Stop engine and remove key.

b)Inflate all four tires to 13 psi (90 kPa).

5.1.11Check battery electrolyte level:

Service Interval: 40 hrs.

a)Stop engine and remove key.

b)Tilt seat up.

c)Remove vent caps from battery. Fill with water (distilled is recommended) to bottom of vent wells and replace vent caps.

d)See Assembly Section 3.8, for servicing a new battery.

PART NO. 513747

LOCATION: Top Center of Console

 

Under Front of Seat

5.1.12Check condition of belts:

Service Interval: 40 hrs.

a)Stop engine and remove key.

b)Check under engine deck to check pump drive belt.

c)Remove left and right belt shields on deck and lift up floor pan to inspect deck drive belt.

d)See Sections 5.2.3 and 5.2.4, for belt adjustment.

5.1.13Lubricate grease fittings:

Service Interval: Refer to chart.

a)Stop engine and remove key.

b)Lubricate fittings with one to two pumps of SAE No. 2 multi-purpose gun grease.

Refer to the following chart for fitting locations and lubrication schedule.

LUBRICATION CHART

 

FITTING

INITIAL

NO. of

SERVICE

 

LOCATIONS

PUMPS

PLACES

INTERVAL

1.

Front Casters

2

2

40 hours

2.

Front Caster Pivots

0

2

∗∗ yearly

3.

Height Adj. Shaft Brngs.

1

5

40 hours

4.

Deck Drive Belt Idler Arm

1

1

40 hours

5.

Brake Brackets

1

2

200 hours

6.

Pump Drive Belt Idler Arm

1

1

40 hours

7.

Deck Rear Struts

1

2

40 hours

More often if operating under severe conditions.

∗∗See 5.1.13 Section c) for special lubrication instructions.

- 23 -

Page 28
Image 28
Exmark LAZER ZTM manual Lubrication Chart, Service Interval 40 hrs, Service Interval Refer to chart