Checking the Engine Oil Level
Before you use the lawn mower, make sure that the oil level is between the Add and the Full marks as shown on the dipstick (Fig. 6). If the oil level is below the Add mark, and oil. Refer to Filling the Crankcase with Oil on page 7.
Checking the Blade Brake Clutch
Refer to Checking the Blade Brake Clutch on page 10.
Cleaning the Underside of the Lawn Mower Housing
To ensure the best performance, keep the underside of the lawn mower housing clean (Fig. 19).
796
Figure 19
Washing Method
1.Position the lawn mower on a flat concrete or asphalt surface near a garden hose.
2.Start the engine.
3.Hold the running garden hose at handle level and direct the water to flow on the ground just in front of the right rear tire (Fig. 20).
1
1093
Figure 20
1. Rear right wheel
4.Engage the blade.
Note: The blade will draw in water and wash out clippings. Let the water run until you no longer see clippings being washed out from under the housing.
5.Disengage the blade, stop the engine and wait for all moving parts to stop.
6.Turn off the water.
7.Start the lawn mower, engage the blade, and let the lawn mower run for a few minutes to dry out its components.
Scraping Method
If washing does not remove all debris from under the lawn mower, scrape it clean.
1.Disconnect the wire from the spark plug (Fig. 9).
2.Drain the fuel from the fuel tank. Refer to Emptying the Fuel Tank and Cleaning the Fuel Filter on page 19.
Warning
Tipping the lawn mower may cause the fuel to leak from the carburetor or the fuel tank. Gasoline is extremely flammable, highly explosive, and, under certain conditions, can cause personal injury or property damage.
Avoid fuel spills by running the engine dry or by removing the gasoline with a hand pump; never siphon.
3.Tip the lawn mower onto its right side (Fig. 19).
4.Remove the dirt and grass clippings with a hardwood scraper. Avoid burrs and sharp edges.
5.Turn the lawn mower upright.
6.Fill the fuel tank.
7.Connect the wire to the spark plug.
15
