8.Install the BBC shield. Rotate the tabs 180 back into position. Tighten the nuts or the bolts on tabs to secure the BBC shield to the deck.
9.Install the blade, the accelerator, the
10.Turn the lawn mower upright.
11.Connect the wire to the spark plug.
Emptying the Fuel Tank and Cleaning the Fuel Filter
The fuel filter (screen) element is located inside the fuel tank. Clean the fuel filter element every 100 operating hours.
1.Stop the engine and wait for it to cool down.
Important Drain gasoline from a cold engine only.
2.Disconnect the wire from the spark plug (Fig. 9).
3.Close the fuel valve (Fig. 3).
4.Disconnect the fuel line (Fig. 33) by loosening the tube clamp at the carburetor.
5.Open the fuel valve by turning the lever to the open position (Fig. 7).
6.Drain the gasoline completely from the tank and fuel line into an approved fuel container.
7.Remove the fuel tank from the mower.
8.Close the fuel valve.
9.Pour a small amount of fuel in the fuel tank, move the fuel around in the tank, and pour it out into an approved fuel container.
10.Install the fuel tank and fuel line; refer to Installing the Fuel Tank and the Fuel Line on page 6.
Cleaning under the Belt Cover
Keep the area under the belt cover free of debris.
1.Stop the engine and wait for all moving parts to stop.
2.Disconnect the wire from the spark plug (Fig. 9).
3.Remove the bolts that secure the belt cover (Fig. 28) to the lawn mower housing.
1
Figure 28
1. Belt cover
4.Lift off the cover and brush out all the debris around the belt area.
5.Install the belt cover.
6.Connect the wire to the spark plug.
Lubricating the Pivot Arms
After every 50 operating hours or when the season ends, lubricate the pivot arms.
1.Move the rear wheel cutting height levers to the center setting.
2.Wipe the grease fittings with a clean rag (Fig. 29).
1
Figure 29
1. Grease fitting
3.Install a grease gun onto the fitting and gently apply 2 or 3 pumps of #2
Note: Excessive grease pressure may damage the seals.
19
