Extron electronic 68-1021-01 user manual Three, Connection and Configuration, Ipl M Pdp-Es

Installation and Operation, cont’d

•If events are currently running following the momentary (<1 second) press, the Power LED flashes three times, indicating the stopping of events.

Each flash lasts for .25 seconds. Nothing happens if the momentary press does not occur within 1 second.

Mode 4 — Holding the reset button until the Power LED blinks twice (6 seconds), followed by a momentary (<1 second) press resets IP settings. The Power LED blinks four times in quick succession, confirming a mode 4 reset. This mode does the following:

1.Enables ARP program capability.

2.Sets the IP address back to its factory IP address.

3.Sets the Subnet address back to its factory default.

4.Sets the Gateway back to its factory default.

5.Sets Port mapping back to its factory default.

6.Turns DHCP off.

7.Turns events off.

Nothing happens if the momentary press does not occur within one second.

Mode 5 — Holding the reset button until the Power LED blinks three times (9 seconds) followed by a momentary

(<1 second) press causes an absolute system reset back to factory default conditions (except for firmware upgrades). Nothing happens if the momentary press does not occur within 1 second. The power LED blinks four times in quick succession, confirming a mode 5 reset.

IPL M PDP-ES

Chapter3Three

Connection and Configuration

Connecting the Hardware

Configuring the Hardware

2-8 IPL M PDP-ES • Installation and Operation