Extron electronic CIA114F5 Installation, cont’d, 6 - Attaching the wall box to a wall stud

Installation, cont’d

6. Insert the wall box into the opening, and attach it to the wall stud or furniture with nails or screws, leaving the front edge flush with the outer wall or furniture surface (figure 2-6).

Wall Stud

Screws or Nails

Cable Clamp

Installation Cable

2-gang Wall Box

	NITO	R
NO MO

	E SH	IFT
IMAG
			OUT	PUT
	MONI	TOR
			INPU		T
		UTER
COMP

		INPU	T
AU	DIO		to
			Au er
			Pow

Extron

CIA111

Extron

MAAP

Figure 2-6 — Attaching the wall box to a wall stud

If attaching the wall box to wood, use four #8 or #10 screws or 10-penny nails. A minimum of 1/2 inch (1.3 cm) of the screw threads must penetrate the wood.

If attaching the wall box to metal studs or furniture, use four #8 or #10 self-tapping sheet metal screws or machine bolts with matching nuts.

7. Set the DIP switches and cable and test the interface before fastening the interface into the wall box. The switches and cables will be inaccessible after installation. See "Side Panel Features and Cabling", earlier in this chapter, for more information.

Mounting optional MAAP devices (CIA111 only)

The interface and any optional MAAPs must be cabled before the interface is installed in a wall or furniture. The hex screws needed to attach the MAAPs to the interface are provided with the MAAPs, so no additional screws are needed.

1. Before any cables are attached to the front of an MAAP device, secure the MAAP to the faceplate with the provided 3/32" hex screws (figure 2-7).

Figure 2-7 — Mounting the optional MAAP device (standard MAAP device shown)

2. Follow steps 3 through 9 in the "Installation Overview" section of this chapter. For step 8 (mounting the interface to the wall box), see "Mounting the interface to the wall box", on the next page.

2-10 CIA111 and CIA114 • Installation and Operation CIA111 and CIA114 • Installation and Operation 2-11