| Balanced Stereo | Unbalanced Stereo |
Left Tip (+) |
| Left Tip (+) |
|
| |
Left Ring |
| Sleeve |
Sleeve (s) |
| Right Tip (+) |
Right Tip (+) | AUDIO | AUDIO |
Right Ring | OUTPUT | OUTPUT |
| CONFIG | CONFIG |
| JUMPER POSITION | JUMPER POSITION |
| OFF = DUAL MONO | OFF = DUAL MONO |
| ON = STEREO | ON = STEREO |
Set Audio Output jumper to Stereo. | Set Audio Output jumper to Stereo. |
Balanced Mono |
| Unbalanced Mono |
Use either the left or the right channel. |
| Use either the left or the right channel. |
Tip (+) | Tip (+) |
|
Ring |
| |
|
| |
Sleeve | Sleeve | AUDIO |
AUDIO | ||
OUTPUT |
| OUTPUT |
CONFIG |
| CONFIG |
JUMPER POSITION |
| JUMPER POSITION |
OFF = DUAL MONO |
| OFF = DUAL MONO |
ON = STEREO |
| ON = STEREO |
Set Audio Output jumper to Dual Mono. Set Audio Output jumper to Dual Mono.
CAUTION Connect the sleeve to ground (Gnd). Connecting the sleeve to a negative
| N Balanced audio is more resistant to noise and can be driven | |
| for longer distances than unbalanced audio. For best |
|
| results, wire the output for balanced audio. |
|
C | Video output connector (green cable) — Connect a composite | |
| video output device to the BNC connector. |
|
| ||
| an |
|
|
| |
| chroma of an |
|
D | Audio output jumper — Set this jumper to select either stereo | |
| (jumper on) or dual mono (jumper off) output. |
|
| When set for dual mono, the left and right channels output the | |
| same signal (either channel or both channels can be used). The | |
| audio output can be wired for balanced/unbalanced mono or | |
| stereo output. The wiring and the jumper setting must match. | |
E | Output gain potentiometer (chroma) — Use a small |
|
| screwdriver to rotate this potentiometer to adjust the chroma |
|
| gain when the line driver is connected to long output cables. |
|
| The adjustment range is 0 dB to +10 dB. The default is unity |
|
| (the dot position). See "Gain adjustment control" in this chapter. | |
| CSVEQ 100 D • Operation |