Extron electronic Quick Start Guide - CSVEQ 100 D, Step, CSVEQ 100 D Quick Start Guide QS-1

Quick Start Guide — CSVEQ 100 D

CInstallation and service must be performed by authorized personnel only. These line drivers must be used with UL approved, grounded electrical boxes.

To install and set up the line driver, follow these steps and see the appropriate sections of this manual for details.

Step 1

Turn the input and output devices off and unplug their power cords.

Verify that the line driver is disconnected from the power source before proceeding.

Step 2

Attach output cables to the rear panel of the line driver and to the output devices. See "Rear Panel Features and Operation" in chapter 3 for details.

Step 3

Attach input cables from the input devices to the line driver’s front panel input connectors. See "Front Panel Features and Operation" in chapter 3.

Step 4

Connect power cords and turn on the output devices (projector/­ monitor, speakers) and input devices.

Step 5

The picture should appear and sound should be audible. If not, ensure that all devices are plugged in and receiving power. Check the cabling, make adjustments as needed. For further details, see "Testing and troubleshooting" in chapter 2.

Step 6

While watching the display, adjust the video gain and equalization by using the rotary gain and equalization (EQ) control potentiometers. An oscilloscope can be used to achieve a more precise adjustment. See “Gain adjustment control" and "Equalization (EQ) adjustment control” in chapter 3 for details.

Make all adjustments using an Extron Tweeker or small screwdriver. If using very short output cables, set all potentiometers to the default setting (the arrow on the control pointing to the dot beside it).

CSVEQ 100 D • Quick Start Guide QS-1