Extron electronic Replacing the Decora Faceplate, CSVEQ 100 D Operation, Operation, cont’d

Operation, cont’d

Use a small, flat-blade screwdriver to rotate this control. View the display and select the setting that gives the sharpest picture. For a more precise setting, you can use an oscilloscope or a waveform monitor connected to the far end of the output cable, and adjust the equalization so that the color burst ranges between -20 IRE and +20 IRE.

NThe EQ control is a potentiometer with a mechanical stop at the high and the low end. After you have reached the high or low end of the adjustment, no change is apparent on the display. The default is set to 0 dB (the dot position).

Replacing the Decora Faceplate

The front faceplate is replaced by removing the two rear panel mounting screws, replacing the faceplate, then reattaching the two screws, as shown in the CSVEQ 100 D example below.

CSVEQ 100 D

VIDEO

OUTPUT

AUDIO

OUTPUT

CONFIG

JUMPER POSITION OFF = DUAL MONO ON = STEREO

AUDIO OUTPUT

C	GAIN
	EQ
Y	GAIN
VIDEO	EQ GAIN

Mounting

Screws

Faceplate (rear)

Removing the CSVEQ 100 D faceplate

3-8 CSVEQ 100 D • Operation