Extron electronic DTP DVI 230 manual Connector and Cable Details

JRS-232 and IR connector — Connect a serial RS-232 signal, a modulated IR signal, or both to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232 and IR communication (see RS-232 and IR connector wiring on page 9 to wire the connector).

KPower input connector — Plug the included external 12 VDC power supply into either this 2-pole connector or the power input connector on the transmitter (see item F on the previous page) (see Power supply wiring on page 8 to wire the connector).

NOTES:

•One power supply is included with the transmitter and normally can power both units.

•If you have removed the ground jumpers (see Disconnecting the Ground on page 11) because of ground potential differences, one DTP DVI 230 unit cannot remotely power the other unit. Each unit requires a local power supply.

Connector and Cable Details

TP cable termination and recommendations

Figure 5 details the TIA/EIA T 568B wiring standard. Use this standard to terminate TP cables with RJ-45 connectors.

Side		Pins:
	1 2 3 4 5 6 78
				TIA/EIA T
				568 B
			Pin	Wire color
			1	White-orange
			2	Orange
			3	White-green
			4	Blue
			5	White-blue
		Insert	6	Green
	7		White-brown
				Twisted
	8	Brown
			Pair Wires

Figure 5. TP Cable Termination

NOTE: Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201

cable to link the transmitter and receiver. The DTP DVI 230 Tx/Rx does not work properly with these cables.

DTP DVI 230 Tx/Rx Transmitter and Receiver • Installation and Operation 6