Power supply wiring
NOTES:
•One power supply is included with the transmitter and normally can power both units.
•If you have removed the ground jumpers (see Disconnecting the Ground on page 11) because of ground potential differences, one DTP DVI 230 unit cannot remotely power the other unit. Each unit requires a local power supply.
Figure 6 shows how to wire the connector. Use the supplied tie-wrap to strap the power cord to the extended tail of the connector.
Smooth 
Ridges
A | A |
|
| SECTION |
|
| Power Supply | Tie Wrap |
| Output Cord |
|
| 3 | 5 |
Figure 6. Power Connector Wiring
CAUTION: Electric shock hazard —
•The two power cord wires must be kept separate while the power supply is plugged in. Remove power before wiring.
•The length and preparation of exposed wires is important (see the second and third audio connector NOTES on page 5 for details).
ATTENTION:
•This product is intended to be supplied by a Listed Power Unit marked “Class 2” or “LPS,” rated 12 VDC, 1.0 A minimum. Always use a power supply supplied by or specified by Extron. Use of an unauthorized power supply voids all regulatory compliance certification and may cause damage to the supply and the end product.
•Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling spaces or in wall cavities.
•The installation must always be in accordance with the applicable provisions of National Electrical Code ANSI/NFPA 70, article 75 and the Canadian Electrical Code part 1, section 16. The power supply shall not be permanently fixed to a building structure or similar structure.
•Power supply voltage polarity is critical. Incorrect voltage polarity can damage the power supply and the unit. The ridges on the side of the cord (see figure 6) identify the power cord negative lead.
To verify the polarity before connection, plug in the power supply with no load and check the output with a voltmeter.
DTP DVI 230 Tx/Rx Transmitter and Receiver • Installation and Operation | 8 |
