![](/images/new-backgrounds/1158991/15899117x1.webp)
Installation and
Operation
This section describes the installation and the operation of the DTP DVI 230 Tx/Rx Extender, including:
•Mounting the Units
•Connections
•Operation
Mounting the Units
Mounting instructions can be found in Mounting the Transmitter or Receiver on
page 10. Compatible optional hardware is listed on the Extron website (www.extron.com).
ATTENTION:
•Installation and service must be performed by authorized personnel only.
•Avoid ground potential differences between the transmitter and receiver installation sites, which can lead to equipment damage or a missing or unstable picture. If a potential difference cannot be avoided, remove the ground connection between the units and locally power both units (see Disconnecting the Ground on page 11). In this configuration, the DTP DVI 230 cannot extend analog audio and each unit requires a local power supply.
Connections
Transmitter Connections
POWER | DDC ROUTE | |
| REMOTE | |
12V |
| |
|
| |
0.8 A MAX | ON |
|
|
| |
| 1 | 2 |
SPARE LOCAL
Rear 6
SIG |
| LINK | OVER DTP | INPUTS | LOCAL OUTPUT |
|
|
|
|
| AUDIO | |
|
| IR |
| ||
|
|
|
| ||
DTP OUT | Tx Rx | G | Tx Rx |
| DTP DVI 230 Tx |
5 | 4 | Front | 3 | 1 | 2 |
|
Figure 2. DTP DVI 230 Tx Connectors
ADVI input connector — Connect an DVI cable between this port and the DVI output port (or HDMI port, with an appropriate adapter) of the digital video source.
DTP DVI 230 Tx/Rx Transmitter and Receiver • Installation and Operation | 3 |