![](/images/new-backgrounds/1158991/15899135x1.webp)
3.Locate, lift off, and discard jumpers JMP2 and JMP3 from both units (see figure 10).
JMP2
JMP3
JMP2
JMP3
Transmitter | Receiver |
Figure 10. Jumper Locations
4.Reinstall the covers on both units, securing them in place with the screws removed in step 2.
5.Reinstall both units in their racks or other installation option (see Mounting the Transmitter and Receiver on page 10).
6.If you are using shielded cable, disconnect the cable shield from the connector at either end of the cable.
7.Obtain a second 12 V power supply (one supply is provided with the transmitter and normally powers both units), and locally power both units (see Power supply wiring on page 8).
DTP DVI 230 Tx/Rx Transmitter and Receiver • Reference Information 12