Extron electronic manual Front Panel Controls and Indicator, DVI-RGB 200 Front Panel

Front Panel Controls and Indicator

8 9 10

LEVEL	PEAK
BOOST	CONTROL	DVI-RGB 200

DVI TO RGB CONVERTER

Figure 4. DVI-RGB 200 Front Panel

HPower LED — The two-tone Power LED lights amber or green:

•Amber when the DVI-RGB 200 is receiving power but no DVI input signal is applied.

•Green when the DVI-RGB 200 is receiving power and a DVI input is present.

ILevel Boost control — The Level Boost control alters the brightness of the picture on the RGB output. Judge the adjustment visually by looking at the display.

•At the minimum level setting (the counterclockwise limit of this control), the interface outputs video at 0.7 Vp-p.

•At the maximum level setting (the clockwise limit of this control), the interface outputs video at 1.45 Vp-p.

Select a level setting of 0.7 V and above to compensate for the signal level decrease that occurs with long cables. Set the level at the maximum setting for cable lengths over 500 feet.

NOTE: Level Boost has no effect on the DVI output of the Buffered Loop-through

connector.

J Peak control — The Peak (peaking) control affects the sharpness of the picture on the RGB output. Increased peaking can compensate for detail (mid- and high-frequency) loss from low bandwidth system components or capacitance in long cables. The minimum setting (at the counterclockwise limit) provides no peaking. The maximum setting (at the clockwise limit) provides 100 percent peaking. Adjust this control while viewing the displayed image to obtain the optimum picture sharpness.

NOTE: Peaking has no effect on the DVI output of the Buffered Loop-through

connector.

DVI-RGB 200 • Installation and Operation 5