Extron electronic DVI DA8 Plus Under-deskmounting, Under furniture mounting the DVI DA4 Plus

Under-desk mounting

Mount the DVI DA6 Plus or DVI DA8 Plus (not shown) under furniture, using the optional Extron MBU 149 under-desk mounting kit (part # 70-222-01). Mount the DVI DA4 Plus using the optional Extron MBU 125 under-desk mounting kit (part

#70-077-01) as shown in the figure below. Follow the same instructions with either kit:

Under furniture mounting the DVI DA4 Plus

To mount the unit under a desk or table:

1.If necessary, remove rubber feet from the bottom of the unit.

2.Secure the under-desk mounting brackets to the unit with the four (DVI DA4 Plus) or eight (DVI DA6 Plus/DVI DA8 Plus) provided #8 screws.

3.Hold the unit, with the mounting brackets attached, under the furniture where it will be secured. Mark the position of the holes on the underside of the furniture.

4.In the marked positions, drill four pilot holes 3/32" in diameter and 1/4" deep.

5.Insert the four provided wood screws into the pilot holes and tighten until approximately 1/4" of the screw head is protruding.

6.Guide the holes of the mounting brackets over the protruding screw head and slide the unit forward or backward to seat it firmly under the furniture.

7.Tighten all four wood screws to secure the unit in place.

DVI DA Plus Series • Installation and Operation 2-5