Rear Panels and Connections
Most of the connectors are on the rear panels of the DXP switchers. The following figures show the rear panels of the four DVI models and the four HDMI models.
NOTE: The illustrations below show DXP 88 DVI Pro and
DXP 88 HDMI models, with 8 input and 8 output connectors. 
The rear panels of the other DXP models are identical to these models except for the number of inputs and outputs
(see "About the DXP DVI Pro and DXP HDMI Series Matrix
Switchers" in the "Introduction" section for the available matrix sizes).
1 | 2 | 3 |
|
| DVI PRO - HDCP COMPLIANT |
1 | 2 | 4 | 1 | 2 | 4 | ||
5 | 6 | 7 | 8 | 5 | 6 | 7 | 8 |
LISTED
C
US1T23I.T.E.
| Figure 3. DXP DVI Pro Rear Panel |
|
|
| ||||
1 |
| 2 |
|
|
|
| 3 |
|
|
|
|
|
| HDMI - HDCP COMPLIANT |
|
|
|
1 | 2 | HDMI INPUTS | 3 | 4 | 1 | 2 | HDMI OUTPUTS 3 | 4 |
5 | 6 |
| 7 | 8 | 5 | 6 | 7 | 8 |
LISTED
C
US1T23I.T.E.
Figure 4. DXP HDMI Rear Panel
4 |
|
LAN | RESET |
| |
| LINK |
| ACT |
REMOTE | RS232/RS422 |
4 |
|
LAN | RESET |
| |
| LINK |
| ACT |
REMOTE | RS232/RS422 |
5
6
7
5
6
7
WARNING: Remove power from the system before making any 
connections.
CAUTION: Use electrostatic discharge precautions (be electrically grounded) when making connections. Electrostatic discharge (ESD) can damage equipment, although you may not feel, see, or hear it.
AAC power connector — Plug a standard IEC power cord into this connector to connect the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
6DXP DVI Pro and DXP HDMI Series • Setup
