Extron electronic DXP HDMI setup guide Output connectors, RJ-45 Connector and Pinout Tables

COutput connectors —

NOTE: The switchers do not alter the video signal in any way.

The signal that is output by the switcher is in the same format as the input signal.

•• DVI Pro series: Connect DVI output devices to these female 29-pin DVI-I output connectors.

•• HDMI series: Connect HDMI output devices to these female 19-pin type A HDMI output connectors.

DEthernet port — If desired, connect the DXP switcher to a computer, a network WAN or LAN hub, or a control system via this RJ-45 connector. With the Ethernet connection, you can use a computer to control the networked switcher with SIS commands, the Matrix Switchers Control Program, or the embedded HTML pages on the switcher.

Ethernet connection indicators — The Link and Act LEDs indicate the status of the Ethernet connection.

•• Link: Indicates that the switcher is properly connected to an Ethernet LAN. This green LED should light steadily.

•• Act (Activity): Indicates transmission of data on the RJ-45 connector. This yellow LED should flicker as the switcher communicates.

Ethernet links use Category (CAT) 3, 5e, or 6 unshielded twisted pair (UTP) or shielded twisted pair (STP) cables, terminated with RJ-45 connectors. Ethernet cables are limited to 328 feet (100 m).

NOTES: • Do not use standard telephone cables. Telephone

cables do not support Ethernet or Fast Ethernet.

• Do not stretch or bend the cables because this can cause transmission errors.

Pins:

1 2 3 4 5 6 7 8

Insert Twisted

Pair Wires

RJ-45

Crossover Cable

	End 1	End 2
Pin	Wire Color	Wire Color
1	White-green White-orange
2	Green	Orange
3	White-orange White-green
4	Blue	Blue
5	White-blue White-blue
6	Orange	Green

7White-brown White-brown

8Brown Brown

T568A T568B

Straight-through Cable

Pin	End 1	End 2
	Wire Color	Wire Color
1	White-orange	White-orange
2	Orange	Orange
3	White-green	White-green
4	Blue	Blue
5	White-blue	White-blue
6	Green	Green

7White-brown White-brown

8Brown Brown

T568B T568B

Connector

A cable that is wired as T568A at one end	A cable that is wired the same at both ends
and T568B at the other (Tx and Rx pairs	is called a "straight-through" cable, because
reversed) is a "crossover" cable.	no pin or pair assignments are swapped.

Figure 6. RJ-45 Connector and Pinout Tables

8DXP DVI Pro and DXP HDMI Series • Setup