The cable you use depends on your network speed. The switcher supports both 10 Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex and full-duplex, Ethernet connections.

•• 10Base-T Ethernet requires CAT 3 or higher UTP or STP cable.

•• 100Base-T Fast Ethernet requires CAT 5e or higher UTP or STP cable.

Terminate the Ethernet cable as required:

•• Network connection — Wire as a patch (straight-through)cable.

•• Computer or control system connection — Wire as a crossover cable.

NOTE: The factory default IP address is 192.168.254.254.

EReset LED — When the unit is being reset, this LED blinks the appropriate number of times to indicate the level of reset that has been performed.

FReset button — This recessed button initiates four levels (modes) of reset. Use a pointed object such as a small Phillips screwdriver or a stylus to press and hold the Reset button while the switcher is running or being powered up.

•• Hard reset (mode 1) — Hold the Reset button while powering up the switcher to restore the DXP to the default factory conditions. This reset restores the factory-installed firmware.

NOTE: This type of reset does not clear the current configuration.

•• Events reset (mode 3) — Press and hold the Reset button for 3 seconds, then release and press it again momentarily to toggle events monitoring on and off.

•• IP settings reset (mode 4) — Press and hold the Reset button for 6 seconds, then release it and press it again momentarily to reset the switcher IP functions.

NOTE: IP settings reset does not replace any user-installed firmware.

•• Absolute reset (mode 5) — Press and hold the Reset button for 9 seconds, then release it and press it again momentarily to restore the switcher to the default factory conditions.

For more details on these reset modes, see the DXP DVI Pro and DXP HDMI User Guide, available on the provided Extron Product Software DVD or the Extron website at www.extron.com.

DXP DVI Pro and DXP HDMI Series • Setup

9

Page 15
Image 15
Extron electronic 68-1370-50 REV. C, DXP HDMI setup guide DXP DVI Pro and DXP Hdmi Series Setup