Furniture mounting
The EDID 101 can be mounted under furniture using optional mounting kit MBU 125 (part
1.Attach the mounting brackets to the EDID 101 with the provided machine screws as shown in the figure below.
2.Hold the EDID 101 with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes in the brackets on the mounting surface.
3.Drill 3/32" (2.4 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.
4.Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4" of the screw head protrudes.
5.Align the mounting screws with the slots in the brackets and place the EDID 101 and brackets against the surface, with the screws through the bracket slots.
6.Slide the EDID 101 slightly forward or back, then tighten all four screws to secure the unit in place.
Mounting the EDID 101 under a desk
NWhen mounting the EDID 101 under a desk using an MBU 125, the EDID configuration switches located on the side of the product will no longer be accessible. Ensure the EDID 101 is configured prior to mounting. See page 10, "EDID 101D/EDID 101V Operation" for programming details.
EDID 101D/EDID 101V • Installation and Operation | 7 |
