Operation
This section of the manual provides information on:
zz HDMI DA2 Front Panel Features
zz EDID Minder
HDMI DA2 Front Panel Features
|
| 3 |
|
|
|
| INPUT | OUTPUTS |
|
|
| 1 2 | EDID | |
| CONFIG | SIGNAL |
| |
|
|
| ||
|
|
|
| |
|
| HDCP |
|
|
|
|
| HDMI DA2 | |
1 | 2 | 4 |
| 5 |
Figure 7. HDMI DA2 Front Panel
A B C D E
Power status LED USB Config port Signal LEDs HDCP LEDs
EDID LED
Power Status LED
The power status LED lights green when power is applied to the unit.
USB Config Port
The USB Config port is used for SIS configuration, monitoring, and firmware updates. This port can be used as an alternative to the rear panel
NOTES:
•Neither port has precedence and commands from either port are handled in the order they are received.
•Extron recommends that the USB port is used for temporary connections. If a permanent connection is required, the
When the USB Config Port is connected to the HDMI DA2 for the first time, the Found New Hardware Wizard opens to install the correct device driver (see Connecting to the USB Port on page 7).
HDMI DA2 • Operation | 10 |
