Extron electronic HDMI DA2 Signal Status LEDs, Edid Led, Input Signal LED, Output Signal LEDs

Signal Status LEDs

Input Signal LED

The input signal LED lights green when a TMDS signal is detected on the HDMI input. If the source requires HDCP encryption, this LED may light only after the HDCP has been authenticated.

Output Signal LEDs

There are two output signal LEDs, one for output 1 and the other for output 2. The LEDs light green when a TMDS signal is being transmitted to a sink device on the corresponding HDMI output.

Input HDCP LED

The Input HDCP LED lights green when the source device requires HDCP encryption and it has been authenticated with the HDMI input.

Output HDCP LEDs

There are two output HDCP LEDs, one for output 1 and the other for output 2. The LEDs light green when HDCP has been authenticated between the HDMI output and the corresponding sink device. This happens when the source device requires HDCP encryption and it has already been authenticated on the HDMI input.

The LEDs do not light if the source does not require HDCP encryption or if the sink is not HDCP compliant. If HDCP encryption is required but the sink device is not HDCP compliant, that output channel outputs a green screen.

EDID LED

The EDID LED lights green when the EDID is successfully stored from the selected output device (output 1 by default).

The LED lights amber if the internal, factory-installed EDID is used or if the EDID was not successfully stored.

For information about using the EDID Minder, see EDID Minder on page 12.

HDMI DA2 • Operation 11