Operation, cont’d

ISS 408 Integration Seamless Switcher • Operation3-18

Picture adjustments
The picture adjustments allow you to fine tune the image quality of the selected
input. When you press one of the Picture Adjustments buttons (Color/Tint,
Brightness/Contrast, Size, Center, or Filter) once, the corresponding image
adjustment menu for the preview image appears on the LCD screen. Press the
button again, and the corresponding image adjustment menu for the program
image appears. In either screen, adjustments can then be made by rotating the
Adjust knob or the Adjust knob. Picture adjustment settings are stored in
nonvolatile memory; when the switcher is powered down and powered up, the
settings are restored.
Adjust an image for centering, sizing, brightness, contrast, color, tint, zoom, or
detail as follows (figure 3-17).
10 sec.
timeout
2 sec.
2 sec.
Display
Cycle
Power
on
NOTE The Adjust knob and the Adjust knob are used to adjust the
image settings on the left and right sides of the LCD screen, respectively.
COLOR/
TINT
BRT/
CONT
SIZE CENTER FILTER
Extron Electronics
ISS 408 with DVI
Integration
Seamless Switcher
Extron Electronics
ISS 408 with DVI
60-423-01
Version
x
.
xx
Preview
Color Tint
127 128
Press again for Prog
Preview
Brightness Contrast
063 063
Press again for Prog
Preview
Horz Size Vert
450 400
Press again for Prog
Preview
Horz Center Vert
500 550
Press again for Prog
Preview
Horz Filter Vert
3 7
Press again for Prog
10 sec.
timeout
COLOR/
TINT
BRT/
CONT
SIZE CENTER FILTER
Program
Color Tint
127 128
Press again for Prev
Program
Brightness Contrast
063 063
Press again for Prev
Program
Horz Size Vert
450 400
Press again for Prev
Program
Horz Center Vert
500 550
Press again for Prev
Program
Horz Filter Vert
3 7
Press again for Prev
Figure 3-17 — Picture adjustments flowchart
1. Press the desired input button to select the input to adjust.
The adjustments are made to the input signal as it is switched to the output
(preview or program) shown in the LCD only. The adjustments do not affect
the same input switched to the other output.
Color adjustments are available only for component video, S-video, and
composite video inputs.
Tint adjustments are available only for S-video and composite video inputs.