Manuals / Extron electronic / Computer Equipment / Switch

Extron electronic MCP 1000 user manual Three, Operation, Front Panel Features Application Examples

Models: MCP 1000

1 21

Download 21 pages 14.14 Kb

Page 12

Image 12

Installation, cont’d

MCP 1000 Remote Control Panel

Chapter3Three

Operation

Front Panel Features

Application Examples

Setting Up the Operation Mode

2-10 MCP 1000 • Installation

Page 12

Image 12

Extron electronic MCP 1000 user manual Three, Front Panel Features Application Examples, Setting Up the Operation Mode

Contents

Remote Control Panel User’s Manual68-456-01 Rev. C 2007 Extron Electronics. All rights reservedPrecautions Extron’s WarrantySafety Instructions English FCC Class A Notice噝噝噝噝噝噝噝 Table of Contents PrecautionsMCP 1000 Table of Contents Comm-link connectors master or slaveMCP 1000 Remote Control Panel Table of Contents, cont’dSetting Up the Operation Mode About this Manual About the MCP FeaturesFeatures IntroductionAbout this Manual About the MCPInstallation Using the Button Label GeneratorUsing the MCP 1000 with an MKP 1000 and a Matrix 3200/6400 switcher connectors master or slave in chapterInstallation MCP 1000 InstallationMCP 1000 rear panel connectors Mounting the MCPInstallation, cont’d RS-232 connectors masterComm-link connectors master or slave MCP 1000, host controller, and switcherDamage may occur to circuits if cable wire Wiring the 5 mm captive screw plugsassignments are not the same on both ends Trimming the cable jacketInstallation, cont’d Changing the Front Panel Button Labels Using the Button Label GeneratorInstalling the software Using the softwareFront Panel Features Application Examples Setting Up the Operation Mode2-10 MCP 1000 Installation Chapter3ThreeFront Panel Features Do not use delay or pause characters in RS-232commands. Use contiguous SIS commands MCP 1000M, SW6 switcher, and host computerOutput mode and preset mode on a MAV Plus 1616 A Operation, cont’dSlave applications comm-link Audio breakaway is not available in matrix modeMaster/slave applications RS-232/comm-link Star/daisy-chain conﬁgurationDaisy-chain conﬁguration Star conﬁgurationOperation, cont’d Setting Up the Operation Mode Using setup modeTesting lights Preset modeSetup ﬂow charts MCP 1000 slave mode ﬂow chart3-10 MCP 1000 Operation Room modeSpeciﬁcations, Part Numbers and Accessories MCP 1000 master mode ﬂow chartAAppendix A Speciﬁcations Included Parts CablesSpeciﬁcations, Part Numbers, and Accessories MCP 1000 Speciﬁcations, Part Numbers, and AccessoriesSpeciﬁcations Included PartsSpeciﬁcations, Part Numbers, Accessories, cont’d MCP 1000 Speciﬁcations, Part Numbers, and AccessoriesMCP 1000 Speciﬁcations, Part Numbers, and Accessories A-6 MCP 1000 Speciﬁcations, Part Numbers, and Accessories Speciﬁcations, Part Numbers, Accessories, cont’d