P/2 DA4xi and P/2 DA6xi, cont’d
Through-desk mounting
The P/2 DA4xi/6xi can be mounted using the optional
1.Attach the mounting brackets to the DA with the screws provided (shown below).
2.Mark the opening, 1.6" x 8.7" (4.1 cm x 22.1 cm), through which the unit will be mounted.
3.Cut the proper sized hole in the mounting surface.
4.Hold the DA with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.
5.Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.
6.Insert four #8 wood screws through the bracket and into the four pilot holes. Tighten all four screws to secure the DA in place.