P/2 DA4xi and P/2 DA6xi, cont’d
Operation
After the distribution amplifier and its connected devices are powered up, the system is fully operational. If any problems occur, verify that the cables are properly routed and connected.
Signal input and output connections
All connections, including power, input, and output, are located on the rear panel of the P/2 DA4xi and P/2 DA6xi.
To make input and output connections to other devices, do the following:
1.Turn off the PC and local monitor.
2.Connect the input cable from the P/2 distribution amplifier (DA) to the computer’s
If you wish to send RGBHV, RGBS, RGBsB, RsGsBs, component video,
RGBHV
R G B H V
RGBS
R G B H V
RGsB, |
|
|
|
|
RsGsBs, |
|
|
|
|
Component | G | B | H | V |
R | ||||
|
|
|
| |
R | G | B | H | V |
Composite |
|
|
|
|
R | G | B | H | V |
3.Connect the computer’s monitor to the Local Monitor output of the DA.
4.Connect
5.Connect power to the distribution amplifier.
6.Turn on the local monitor, other display devices, and the PC.