or- autions when usirsa
IMPORTANT NOTE
•Handle the liquid crystal display (LCD) with care:
The LCD is a very delicate display device: Do not press its surface with force, hit it or prick it with a sharp obiect.
-If you push the LCD surface, unevenness in display may occur, if unevenness does not disappear, turn the camcorder off, wait for a few moments, then turn it on again.
Do not place the camcorder with the open LCD screen down. Close the LCD monitor when not using the camcorder.
°Liquid crystal display :
-The LCD screen will be slightly dimmer than usual when the camcorder is at low temperature, as in cold areas,
or immediately after power is turned on. Normal brightness will be restored when the temperature inside tile camcorder rises. This has no effect on the images in the storage media, so there Ksno cause for concern.
•Hold the DVD camcorder correctly:
-Do not hold the DVD camcorder by the LCD monitor when lifting it: the viewfinder or LCD monitor could detach and the DVD camcorder may fall.
Do not subject the DVD camcorder to impact:
-This DVD camcorder is a precision machine. Take great care that you do not strike it against a hard object or let it fall.
-Do not use the DVD camcorder on a tripod in a place where it is subiect to severe vibrations or impact.
•No sand or dust!
Fine sand or dust entering the DVD camcorder or AC power adaptor could cause malfunctions or defects.
°No water or oil!
Water or oil entering the DVD camcorder or AC power adaptor could cause electric shock, malfunctions or defects.
•Heat on surface of product:
The surface of the DVD camcorder will be slightly warm when in use, but this does not indicate a fault.
•Be careful of ambient temperature:
Using the DVD camcorder in a place where the temperature is over 60°C (140°F) or under 0°C (32°F) will result in
abnormal recording/playback.
Do not leave the DVD camcorder on a beach or in a closed vehicle where the temperature is very high for a long time: This could cause a malfunction.
•Do not point directly at the sun:
If direct sunlight strikes the lens, the DVD camcorder could malfunction or a fire could occur.
Do not leave the DVD camcorder with the LCD screen exposed to direct sunlight: This could cause a malfunction.
o Do not use the DVD camcorder near TV or radio:
This could cause noise to appear on the TV screen or in radio broadcasts.
x_ English
