Extron electronic PS 124, cont’d Connections, Input power using the IEC power cord

PS 124, cont’d

Connections

Input power — using the IEC power cord

Use the included IEC power cord to connect the PS 124 to a 100 VAC to 240 VAC, 50-60 Hz power source.

WThe circuit breaker used for this connection should be rated 20 amps maximum.

Input power — using the Flexible Conduit Adapter Kit

The optional Flexible Conduit Adapter Kit, part # 70-228-02, provides a convenient means to replace the IEC power cord with conduit when required by local codes.

The kit consists of:

•One EMT adaptor plate

•One 6-foot long electrical conduit

•Three 7.5 feet, 18-gauge spade connector power wires

•One UL Listed zip tie wrap

•Three auxiliary crimp style spade connectors designed for 14- to 16-gauge wires

NExtron recommends using a crimp tool such as Molex part #19285-0008to terminate the spade connectors.

Make certain the PS 124 and all connected devices are turned off and disconnected from the power source before beginning.

WThe circuit breaker used for this connection should be rated 20 amps maximum.

WFor permanently connected equipment there must be a readily accessible disconnect device incorporated in the building installation wiring.

WInstallation and service must be performed by a qualified electrician only.

4 PS 124 12 VDC, 4 Amp Power Supply • Installation Manual