Operation, cont’d
Detail adjustments
To apply a horizontal or vertical filter to improve the sharpness of an image, do the following:
1. | Press and release the Detail button. The button lights. | |
2. | Various levels of detail adjustment are available, | |
| depending on the input signal format. | |
| • | To change the vertical filter (if available), rotate the V |
|
| adjustment knob. Choose the filter that provides the |
|
| most improvement to the image detail. |
|
| The availability of some filters depends on the type of |
|
| |
|
| switcher that is connected. Check your switcher’s user |
|
| manual for to find out if this feature is supported. |
| • | To change the horizontal filter (if available), rotate |
|
| the H adjustment knob. Choose the filter that |
|
| provides the sharpest image. |
Applying and Changing a Switching Effect
You can switch the program and preview inputs using a variety of switching effects. For a description of each effect, and the technique to implement it, see the instructions for the effect in this section. Unless otherwise indicated, the effects are available for both the ISS and SGS switchers.
Cuts
A cut seamlessly replaces the program image with the preview image. No effect is applied to the switch. As soon as the Cut button is pressed, the switch occurs.
To switch using a cut, do the following:
1. | Press the preview input button that corresponds to the |
| input that you want to switch to. |
2. | Press the Cut button. The seamless switch takes effect |
| immediately, and the preview image becomes the new |
| program image. |
Dissolves
A dissolve causes the program image to fade out while the preview image fades in (figure
Dissolve
Figure 3-2 — A dissolve effect
Changing the duration of a dissolveTo change the duration of a dissolve, do the following:
1. | Press the Dissolve button. The Dissolve button lights. |
2. | Rotate the Adjust knob next to the buttons. A duration |
| menu appears on the LCD screen, showing the current |
| duration selected for the dissolve. Select any dissolve |
| duration time from 0.2 to 5.0 seconds. |
Wipes (SGS only)
The different types of wipes available on the RCP 2000 are described in this section.
Standard wipeA standard wipe causes the preview image to appear to unroll over the program image horizontally or vertically. A standard wipe can have either hard (sharp) or soft (fuzzy) edges.
The preview image can have the following transitions (see figure
•From left to right
•From right to left
•From top to bottom
•From bottom to top
Figure 3-3 — Standard wipe transitions
RCP 2000 • Operation | RCP 2000 • Operation |