Extron electronic user manual Three, Operation, Installation, cont’d, RCP 2000 Installation

Installation, cont’d

•When connecting the RCP 2000 directly (no intermediate device present, such as a network hub) to the ISS 108/408, you must use a crossover cable. See the table on the next page for RJ-45 crossover cable connections.

RJ-45 Ethernet Crossover Cable

	RCP 2000 end		Intermediate hub, etc., end
Pin	Wire color	Signal	Pin	Wire color	Signal
1	White-orange	Transmit +	3	White-orange	Receive +
2	Orange	Transmit -	6	Orange	Receive -
3	White-green	Receive +	1	White-green	Transmit +
6	Green	Receive -	2	Green	Transmit -
4	Blue	N/A	4	Blue	N/A
5	White-blue	N/A	5	White-blue	N/A
7	White-brown	N/A	7	White-brown	N/A
8	Brown	N/A	8	Brown	N/A

•When connecting the RCP 2000 indirectly (intermediate device present, such as a network hub) to the ISS 108/408, you must use a patch (straight-through) cable. See the table below for RJ-45 patch cable connections.

RJ-45 Ethernet Patch Cable

	RCP 2000 end		SGS 408, ISS 108/408 end
Pin	Wire color	Signal	Pin	Wire color	Signal
1	White-orange	Transmit +	1	White-orange	Receive +
2	Orange	Transmit -	2	Orange	Receive -
3	White-green	Receive +	3	White-green	Transmit +
4	Blue	N/A	4	Blue	N/A
5	White-blue	N/A	5	White-blue	N/A
6	Green	Receive -	6	Green	Transmit -
7	White-brown	N/A	7	White-brown	N/A
8	Brown	N/A	8	Brown	N/A

RCP 2000 Remote Control Panel

Chapter3Three

Operation

Top Panel Controls

Using the Picture Controls

Applying and Changing a Switching Effect

Resetting the Unit

2-6 RCP 2000 • Installation