Quick Start Guide — RCP 2000, cont’d
Six sizes of
Step 4
Continue the procedure for installing the ISS 108/408 or SGS 408.
Step 5
Attach power cords and plug the ISS or SGS seamless switcher, the input devices, and the output devices into a grounded AC source.
Attach the power cord to the RCP 2000.
Step 6
Select an input using the RCP 2000 top panel (Program input) buttons. The image should now appear.
Step 7
If the image does not appear, do the following:
•Ensure that all devices are plugged in and receiving power.
•Check the cabling and make adjustments as needed.
•Select a different input to check for an image.
Table of Contents
Chapter 1 • Introduction | |
Features | |
Chapter 2 • Installation | |
Rear Panel Connectors | |
Installation | |
Application Example | |
Making an RCP Communication Cable | |
RCP 2000 to ISS 108/408, SGS 408 | |
RCP 2000 to ISS 108/408 Ethernet link | |
Chapter 3 • Operation | |
Top Panel Controls | |
Using the Picture Controls | |
Adjusting color and tint | |
Adjusting contrast and brightness | |
Sizing an image | |
Centering an image | |
Detail adjustments | |
Applying and Changing a Switching Effect | |
Cuts | |
Dissolves | |
Changing the duration of a dissolve | |
Wipes (SGS only) | |
Standard wipe | |
Curtain wipe | |
Plus wipe | |
Square wipe | |
Title | |
Selecting a wipe and a wipe duration | |
Implementing an effect | |
Implementing a title | |
Resetting the Unit | |
Chapter 4 • Remote Control | |
Manual IP Setup | |
Changing the IP addresses | |
Network IP Setup and Control | |
Contacting the RCP unit |
| RCP 2000 • Table of Contents | iii |