Extron electronic RCP 2000 RemoteControl,cont’d Manual IP Setup, Changing the IP addresses

RemoteControl,cont’d

Manual IP Setup

The RCP 2000 unit ships with default server (ISS) and client (RCP) IP addresses, as well as Subnet Mask and Gateway Address, already set. These default IP addresses can be changed to conform to the IP address format required for your network or designated by your network administrator.

Changing the IP addresses

To change the IP addresses:
1. Press the four effects buttons (Wipe, Disolve,
	X X - X X - X X
Cut, and Take) simultaneously until the LCD
	X X - X X - X X
screen shows the RCP unit’s MAC address
(xx-xx-xx-xx-xx-xx), and the Cut button lights.

	PICTURE CONTROLS			H
COLOR	CONT	SIZE	CENTER	DETAIL
TINT	BRIGHT

V	2. After 2 seconds,
	the display shows
	the MAC address.

•Press the Size button and use the H adjust knob to change the third block of the address.

•Press the Center button and use the H adjust knob to change the fourth block of the address.

4.	Press the Take button again. The server IP address (SI) is
	now visible on the LCD screen. Repeat step 3 to change
	the server IP address.
		S 1 9 2	. 1 6 8 .
5.	Press the Take button again. The Subnet
		I 1 2 8	. 1 2 8
	Mask (SM) is now visible on the LCD screen.
	Repeat step 3 to change the Subnet Mask.
6.	Press the Take button again. The Gateway
		S 2 5 5 . 2 5 5 .
	(GM) is now visible on the LCD screen.	M 2 5 5 . 1 2 8
	Repeat step 3 to change the Gateway.
7.	Press the Detail button to exit and to save all
		G 2 5 5	. 2 5 5 .
	address changes.	M 2 5 5	. 2 5 5

3. Use the Picture Controls buttons	2. Use the H adjust knob to
to move between address blocks.
	change the address block.

PROGRAM

2 3 4 5 6 7 8 9 10 11 12

ADJUST

2 3 4 5 6 7 8 9 10 11 12

WIPE DISOLVE

CUT TAKE

1. Press and hold all four buttons.

	PICTURE CONTROLS			H
COLOR	CONT	SIZE	CENTER	DETAIL
TINT	BRIGHT

V

PROGRAM

2 3 4 5 6 7 8 9 10 11 12

PREVIEW

ION

3. The CUT button is lit.

Figure 4-1 — Setting up for an IP address change

2.Press the Take button. The Cut button stays

ADJUST

2 3 4 5 6 7 8 9 10 11 12

PREVIEW

ION

WIPE DISOLVE

CUT TAKE

on, the Take, Cont/Bright, Size, and Center	I 1 9 2	. 1 6 8 .
buttons light, and the Color/Tint button	P 1 2 8	. 1 2 8
blinks. The client IP address (IP) is visible
on the LCD screen.

3.Using the H adjust knob, change the first block of the IP address. Then do one or more of the following::

•Press the Cont/Bright button and use the H adjust knob to change the second block of the address.

1. Press the TAKE button to move between IP addresses.

Figure 4-2 — Making the IP address change

4-2 RCP 2000 • Remote Control RCP 2000 • Remote Control 4-3