Remote Control
There are two ways to control the horizontal shifting feature of an RGB 580xi remote interface: by using the AAP horizontal shift (H. shift) control, or by using an
RS-232 Programmer’s Guide
The interface can be remotely controlled via a host computer attached to the rear panel’s
RECONFIG 
When the remote interface’s RGB video input is disconnected or the horizontal shift control (H. shift) is adjusted from the AAP device (RGB 580xi S/CCS AAP and RGB 580xi SI/CCSI AAP), the interface sends the reconfiguration message. No response is required from the
Chn 
A contact closure selection has been detected from the remote AAP contact closure switch (RGB 580xi I AAP and
RGB 580xi SI/CCSI AAP).
The
The rear panel’s
Pin | Description | |
|
|
|
1 | Tx | Transmit data |
2 | Rx | Receive data |
3 | Gnd | Signal ground |
|
|
|
Tx Rx
Captive Screw Pin Locations
Female
Error responses
When the interface receives a valid SIS command, it executes the command and sends a response to the host device. If the interface is unable to execute the command because the command is invalid or it contains invalid parameters, it returns an error response to the host.
The error response codes and their descriptions are as follows:
E10 – Invalid command
E13 – Invalid value (the number is out of range)
Using the command/response table
The command/response table lists valid command ASCII codes, the interface’s responses to the host, and a description of the
Host-to-interface communications
SIS commands consist of one or more characters per field. No special characters are required to begin or end a command sequence. When a command is valid, the interface executes the command and sends a response to the host device. All
command’s function or the results of executing the command. Lowercase characters are acceptable in the command field only where indicated. The ASCII to HEX conversion table below is for use with the command/response table.
responses from the interface to the host end with a carriage return and a line feed (CR/LF = 
), which signals the end of the response character string. A string is one or more characters.
Interface-initiated messages
When a local event such as a front panel or contact closure selection or adjustment takes place, the interface sends a message to the host. No response is required from the host. The
(C)Copyright 2001, Extron Electronics, RGB 580xi, Vx.xx 
The interface displays the copyright message when it first powers on. Vx.xx is the firmware version number.
ASCII to HEX Conversion Table
• |
RGB 580xi • Remote Control | RGB 580xi • Remote Control |
