Installation and Setup, cont’d
2.Follow steps 3 through 8 in the Installation Overview section of this chapter.
AAP Device Features
RGB 580xi AAP | 3 | 4 |
|
| 3 |
|
|
|
| RGB 580xi S AAP | |
| AUDIO IN | SHIFT |
|
| AUDIO IN |
| COMPUTER IN |
|
|
| COMPUTER IN |
| RGB 580xi |
|
|
| RGB 580xi |
1 | 2 | 1 |
| 2 |
|
|
| 4 |
|
| 3 |
|
|
|
|
| RGB 580xi SI AAP |
|
| SHIFT |
| SELECT | AUDIO IN |
|
|
|
| ||
|
|
|
|
| COMPUTER IN |
|
|
|
|
| RGB 580xi |
|
| 1 | 5 | 2 |
|
DDSP disables the horizontal shifting control.
5Input select button — Pressing this button results in contact closure between pins A and B of the contact closure control connector on the front panel of the RGB 580xi.
Cabling the AAP Device Rear Connectors
Extron’s various AAP devices for the RGB 580xi may come with several rear connectors that may require cabling.
Although the VGA and control cable/LED assembly comes prewired to the captive screw connectors, any subsequent cable assembly replacement will require the following cabling instructions.
To cable the captive screw connectors, refer to the following diagrams and orient the wires according to the view angle of the captive screws. When using Extron’s VGA and control cable assembly (see appendix A, “Optional RGB 580xi AAP Extension Cables” for part numbers), refer to the color of each wire for signal identification.
1Power/signal LED — This LED lights
•amber to indicate that the AAP device is receiving power.
•green to indicate that an active sync signal is present at the input and that the AAP device is receiving power.
The LED flashes green whenever the minimum and maximum limits of the horizontal shift control (H. shift) have been reached.
H. SHIFT
AUDIO
INPUT COMPUTER
SELECT
RGB 580xi SI AAP
2RGB video input connector — Attach a cable from the computer source to this
3Audio input connector — Plug a 3.5 mm stereo plug into this jack for unbalanced audio input. Wire the male plug as shown below.
Tip (L) | Sleeve (GND) |
Ring (R)
Tip (L)
Sleeve (GND)
4Horizontal shift control knob (H. shift) — While viewing the displayed image, rotate this control to move the image to the right or left on the screen. The power/signal LED flashes green whenever the minimum and maximum limits of this control are reached.
3
Red |
|
|
|
|
|
|
|
|
| Lt. Blue |
|
|
|
|
| ||
|
|
|
|
|
| |||
Black | Yellow | Green Purple 1 | 2 |
| ||||
White | Pink | Gray |
|
|
|
| ||
|
|
|
|
|
Example of AAP device rear connectors
1Control connector (J4) — Insert wires into and tighten the screws on the 3.5 mm,
| RGB 580xi • Installation and Setup |