Installation and Setup
Front Panel Features and Cabling
| INPUTS |
|
| SOG | |
AUDIO | ANALOG | CONTROL |
| SERR | NEG SYNC |
| DDSP | COMP SYNC | |||
|
| VIDEO OUTPUT |
| ||
|
| A B C D E |
| ||
|
| LEVEL | PEAKING |
| |
|
|
|
|
|
|
|
|
|
| RGB 580xi |
1 | 2 | 3 | 4 | 5 | 6 | 7 |
4Contact closure control connector — Connect an optional contact closure device to this female
Prewired male control connector
RGB 580xi front panel
1Power/signal LED — This LED lights amber to indicate that the RGB 580xi interface is receiving power, and lights green to indicate it is receiving both power and an input signal.
2Audio input connector — Plug a 3.5 mm stereo plug into this jack for unbalanced audio input. Wire the male plug as shown below.
| Contact Closure |
Contact closure | CONTROL A B CED |
5VDC | |
Contact closure |
|
5VDC |
|
Ground |
|
Contact closure wiring
Male VGA connector
Prewired male control cable connector
|
| Tip (L) | Sleeve (GND) |
|
|
|
|
|
| Ring (R) |
|
|
|
| |
|
|
| Tip (L) |
|
|
|
|
|
|
| Sleeve (GND) |
|
|
| |
|
| Audio input wiring |
|
|
|
| |
| 3 | RGB video input connector — Attach a cable | 6 | 10 | |||
|
| from the computer source to the RGB 580xi | |||||
|
| 1 | 5 | ||||
|
| via this |
|
| |||
|
| 11 | 15 | ||||
|
| pinout table are shown here. |
| ||||
|
|
|
|
| |||
|
|
|
|
| |||
Pin |
| Description | Wire ID | Pin | Description | Wire ID |
|
1 |
| red signal | red coax | 10 | horizontal sync ground | black coax shield | |
2 | green signal | green coax | 10 | vertical sync ground | yellow coax shield | ||
3 |
| blue signal | blue coax | 10 | audio ground | black wire | |
4 | horizontal shift + | green wire | 10 | LED ground | yellow wire | ||
5 | horizontal shift — | brown wire | 10 | shift ground | gray wire |
| |
6 | red coax ground | red coax shield | 11 | audio right | red wire |
| |
7 | green coax ground | green coax shield | 12 | audio left | white wire |
| |
8 | blue coax ground | blue coax shield | 13 | horizontal sync | black coax | ||
9 |
| LED red | orange wire | 14 | vertical sync | yellow coax | |
|
|
|
| 15 | LED green | pink wire |
|
5Video output: level control — This control adjusts picture brightness by compensating for signal amplitude loss caused by cable resistance. See Front Panel Adjustments in this chapter.
6Video output: peaking control — This control adjusts picture sharpness by compensating for cable capacitance caused by long cable runs. See Front Panel Adjustments in this chapter.
7DIP switches — This bank of DIP switches, as illustrated below, controls DDSP (Digital Display Sync Processing), serration pulse output, SOG (sync on green) output, vertical sync width, sync polarity, and composite sync output. Moving a switch up sets it to On and moving it down sets it to Off.
SOG
SERR | NEG SYNC |
DDSP | COMP SYNC |
|
|
|
|
|
|
|
|
RGB 580xi • Installation and Setup | RGB 580xi • Installation and Setup |