Extron electronic SW6 Installation and Operartion, cont’d, Connections, Under furniture mounting

Models: SW6

1 19
Download 19 pages 4.5 Kb
Page 8
Image 8
Installation and Operartion, cont’d

Installation and Operartion, cont’d

Under furniture mounting

If desired, mount the SW6 VGA Audio under a desk or other furniture (figure 2-2) with the optional MBU 129 under-desk mounting bracket (part #70-219-01), as follows:

Remove and discard

(4) screws from top. Replace with supplied screws.

Under Desk

Mounting Bracket

 

(4) Screws

Figure 2-2 — Mounting the unit under a desk

1.

If installed, remove the feet from the bottom of the unit.

2.

Remove and discard the four screws in the top of the

 

switcher.

3.

Using the screws supplied in the mounting bracket kit,

 

secure the mounting brackets to the top of the switcher

 

with the slotted holes on the outside.

4.

Hold the switcher with the attached brackets against the

 

underside of the table or other furniture. Mark the location

 

of the brackets’ slotted screw holes on the mounting

 

surface.

5.

Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)

 

deep in the mounting surface at the marked screw

 

locations.

6.

Insert #8 wood screws into the four pilot holes. Tighten

 

each screw into the mounting surface until just less than

 

1/4” of the screw protrudes.

7.

Align the mounting screws with the slots in the brackets

 

and place the switcher against the surface, with the screws

 

through the bracket slots.

8.

Slide the switcher slightly forward or back, then tighten all

 

four screws to secure the switcher in place.

Connections

100-240V Under furniture mounting 0.3A

50/60 Hz

 

1

 

 

3

 

2

 

Figure 2-3 — SW6 VGA A rear panel (left half)

 

A

AC power connector — Plug a standard IEC power cord

 

into this connector to connect the switcher to a 100 VAC to

 

240 VAC, 50 or 60 Hz power source.

 

B

Video Input connectors — Connect up to six RGBHV computer

 

video (VGA–QXGA) to these 15-pin HD connectors.

 

 

N The switcher can also accept RGBS, RGsB, RsGsBs, and

 

 

HDTV component video.

 

C

Video Output connector — Connect an RGBHV (VGA-QXGA)

 

video display to this female 15-pin HD connector.

 

2-4

SW6 VGA Audio • Installation and Operation

SW6 VGA Audio • Installation and Operation

2-5

Page 8
Image 8
Extron electronic SW6 user manual Installation and Operartion, cont’d, Connections, Under furniture mounting