2-5TPS150 Switching and Transmission System • Installation

Remote control connections

7
Contact Closure — If desired, connect an optional CTP150CM control panel
module or other contact closure device to this 8-pin 3.5 mm
captive screw connector. Refer to the CTP150CM manual.
To make your own contact closure device, wire the connector
as shown at right. To issue a switching, volume, or projector
power command, momentarily short the appropriate pin to
ground.
8
RS-232 port — Connect a host device, such as a computer or
touch panel control, to the TPT150 transmitter via this 9-pin
D connector and a null modem serial port cable for serial
RS-232 control (figure 2-6).
Connected
RS-232
device pin Function
TPS150
pin
1
2
3
4
5
6
7
8
9
—
RX
TX
—
Gnd
—
—
—
—
Not used
Receive data
Transmit data
Not used
Signal ground
Not used
Not used
Not used
Not used
51
96
Female
Figure 2-6 — Remote port pin assignments for the TPT150 and TPR150
See chapter 4, Serial Communications, for definitions of the ASCII commands
and instructions to install and use the control software.

Power connection

9
AC power switch — Toggle the AC power switch to the on () position to turn
on the transmitter.
10
AC power connector — Plug a standard IEC power cord into this connector
to connect the transmitter to a 100 to 240VAC, 50 Hz to 60 Hz power source.
Receiver connections
All receiver connectors are on the rear panel (figure 2-7).
FUSE: 1.6A; 250V; TIME DELAY
90-260VAC; 0.25A; 47-63Hz
UTP LINK
SKEW
RGB / VGA
COMPOSITE
VIDEO OUTPUT
S-VIDEO
COMPONENT
RS-232 PORT
R-Y B-YY
REDBLUEGRN
ADJ
USE ONLY WITH 250V FUSE
15
12 13 14 1611 17
Figure 2-7 — TPR150 receiver rear panel connectors

TP input connection

11
TP connector — Connect the free end of the STP or FTP cable from the
transmitter to this RJ-45 female connector on the receiver.
See TP cable termination, on page 2-6, to properly wire the RJ-45 connector.
GND
PROJ PWR
VOL DN
VOL UP
IN4
IN3
IN2
IN1
CONTACT
CLOSURE