QS-1TPS150 Switching and Transmission System • Quick Start
Quick Start — TPS150 Switchingand Transmission System

Installation

Step 1

Turn off power to the input and output devices,
and remove the power cords from them.

Step 2

If desired, mount the TPT150 transmitter in a
rack.

Step 3

If desired, mount the TPR150 receiver using the
included projector bracket.

Step 4

Connect source video devices to the transmitter’s
inputs.
Inputs 1 and 2 — Connect
two RGB video sources.
If desired, connect a
monitor to the Input 1 Local Monitor
connector.
Inputs 3 and 4 —
Connect either
component video,
S-video, or
composite video
sources.
For proper
system operation, connect only one video
format to input 3 and input 4.

Step 5

Connect audio devices to the input 1
through input 4 left and right RCA
connectors.

Step 6

Connect an audio device, such as powered
speakers, to this 3.8 mm, 5-pole captive screw
connector for balanced or unbalanced audio
output.

Step 7

Connect a host device, such as a computer or
touch panel control, to the transmitter via this
9-pin D connector and a null modem serial
port cable for serial RS-232 control.

Step 8

Connect an optional CTP150CM
control panel module or other
contact closure device to this 8-pin
3.5 mm captive screw connector.
See chapter 2, Installation.
To make your own contact closure
device, wire the connector as
shown at right. To issue a
command, momentarily short the
appropriate pin to ground.

Step 9

Connect a shielded twisted pair (STP) cable or
foil shielded pair (FTP) with RJ-45 connectors
between the transmitter and receiver. Ensure
that both ends of the cable are terminated using
the same protocol, either TIA/EIA 568 A or 568 B.
Extron recommends STP or FTP cable
only.
Unbalanced Output
Tip
See caution
Sleeve
Tip
See caution
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
CAUTION
Connect the
sleeve to ground.
Connecting the
sleeve to a
negative (-)
terminal will
damage the audio
output circuits.
R-Y
B-YY
VIDEO
S-VIDEO
L
R
Connected
RS-232
device pin Function
TPS150
pin
1
2
3
4
5
6
7
8
9
—
RX
TX
—
Gnd
—
—
—
—
Not used
Receive data
Transmit data
Not used
Signal ground
Not used
Not used
Not used
Not used
51
96
Female
GND
PROJ PWR
VOL DN
VOL UP
IN4
IN3
IN2
IN1
CONTACT
CLOSURE
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
568 A 568 B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Clip DownSide
1
1&2
3&6 4&5
7&8
2345678
RJ-45
connector
Twisted
Pairs
Blue Blue