Installation, cont’d

TPS150 Switching and Transmission System • Installation2-4

Connect the various video formats as shown in figure 2-4.
INPUT 3
Component
video
Composite
video
S-video
R-Y
B-YY
VIDEO
S-VIDEO
INPUT 3
R-Y
B-YY
VIDEO
S-VIDEO
INPUT 3
R-Y
B-YY
VIDEO
S-VIDEO
Figure 2-4 — Input 3 and input 4 video format connections
4
Input audio connectors — Connect unbalanced stereo or mono audio sources
to these pairs (left and right) of RCA connectors for audio input.

TP and audio output connections

5
TP connector — Connect one end of an STP or FTP cable to this RJ-45 female
connector on the transmitter.
Connect the free end of the same TP cable from the transmitter to the RJ-45
female connector on the receiver.
See TP cable termination, on page 2-6, to properly wire the RJ-45 connector.
Extron recommends the use of STP or FTP cable only.
6
Audio connector — Connect an audio device, such as powered speakers, to
this 3.8 mm, 5-pole captive screw connector for balanced or unbalanced audio
output.
Figure 2-5 shows how to wire the captive screw audio connector. The
connector is included with the transmitter, but you must obtain the cable.
Insert the wires into the appropriate openings in the captive screw connector.
Tighten the screws on top to fasten the wires.
CAUTION
Wiring the audio incorrectly can damage the audio output circuits.
Connect the sleeve(s) to ground (GND). Connecting the sleeve(s) to a
negative (-) terminal will damage audio output circuits.
Unbalanced Output
Tip
See caution
Sleeve(s)
Tip
See caution
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
L
Figure 2-5 — Wiring the audio output connector
The audio output always follows the video switch.