Extron electronic YCS 100 user manual Furniture mounting, Projector mounting

Installation and Operation, cont’d

Furniture mounting

To furniture-mount the YCS 100, use the optional MBU 123 VersaTools under-desk mounting kit (part #70-212-01), as follows.

1.	If rubber feet were previously attached to the bottom of the
	unit, remove them.
2.	Remove the two screws from one side of the YCS. Retain
	the screws for possible later reassembly.
3.	Attach one bracket to the side of the unit, using the
	provided machine screws (see figure 2-6, below).

Figure 2-6 — Preparing the YCS 100 for under-desk mounting

4.	Repeat steps 2 and 3 on the other side of the YCS.
5.	Hold the unit with the attached brackets against the
	underside of the table or other furniture. On the mounting
	surface, mark the location of the bracket’s screw holes.
6.	Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep
	in the mounting surface at the marked screw locations.
7.	Insert #8 wood screws into the four pilot holes. Tighten
	each screw into the mounting surface until slightly less
	than ¼" of the screw head protrudes.
8.	Align the mounting screws with the slots in the brackets
	and place the unit against the surface, with the screws
	through the bracket slots.
9.	Slide the unit slightly forward or back, then tighten all four
	screws to secure it in place.

Projector mounting

To projector-mount the YCS 100, use one of the three optional mounting kits described in the following sections.

Using the PMK 100 Mini Projector Mount Kit

The PMK 100 is a projector mounting kit (part # 70-217-01) designed for use with Extron 1U high, quarter-rack width products like the VersaTools products. It allows them to be mounted near or on a projector support.

Follow these steps to projector-mount the YCS 100 using the PMK 100 kit:

1.	If rubber feet were previously attached to the bottom of the
	unit, remove them.
2.	Remove the two screws from one side of the YCS. Retain
	the screws for possible later reassembly.
3.	Attach the projector mounting bracket to the side of the
	unit, using the provided machine screws.
		Mounting
	Projector	Bolt
	Mounting
	Bracket

Ceiling

Projector

Figure 2-7 — Projector-mounting the YCS 100 using the PMK 100 Projector Mount kit

4.	Secure the unit to a projector mount or other surface by
	inserting the mounting bolt through the bracket’s slotted
	hole.

2-6 YCS 100 • Installation and Operation YCS 100 • Installation and Operation 2-7