Extron electronic YCS 100 Installation and Operation, Installation Overview, Mounting the YCS

Installation and Operation

Installation Overview

To install and set up the YCS 100, follow these steps:

1Mount the YCS 100 on a rack shelf, furniture, or projector bracket if desired.

2Connect your input and output devices to the YCS 100’s rear panel connectors.

3Wire the provided 2-pin captive screw connector to the external power supply. (See Wiring the Power Connector, later in this chapter.)

4Apply power to the YCS 100 and to the input and output devices.

Mounting the YCS 100

The YCS 100 can be set on a table; mounted on a rack shelf; mounted under a desk, podium, or table; or attached to a projector with one of the Extron projector mounting kits.

Tabletop use

Four self-adhesive rubber feet are included with the YCS 100. For tabletop use, attach one foot at each corner on the bottom of the unit, and place the YCS in the desired location.

Rack mounting

For optional rack mounting, do not install the rubber feet. Mount the transcoder on one of the following rack shelves:

•1U 3.5" Deep VersaTools® rack shelf

Standard (RSF 123, part #60-190-20) or Basic (RSB 123, part #60-604-20)

•1U 9.5" Deep rack shelf

Universal (RSU 129, part #60-190-01) or Basic (RSB 129, part #60-604-01)

•1U 6" Deep Rack Shelf

Universal (RSU 126, part #60-190-10) or Basic (RSB 126, part #60-604-10)

Mounting on a rack shelf

1.	If feet were previously attached to the bottom of the YCS,
	remove them.
2.	Mount the YCS 100 on the rack shelf, using two
	4-40 x 3/16" screws in opposite (diagonal) corners to

secure the unit to the shelf (see figures 2-1 and 2-2, on the next page, or figure 2-3 on page 2-4).

2-2 YCS 100 • Installation and Operation

3.	Install blank panel(s) or other unit(s) on the rack shelf as
	desired.

VersaTools Rack Shelf

1/4 Rack Width Front

False Faceplate

Use 2 mounting holes on

opposite corners.

(2) 4-40 x 3/16" Screws

Figure 2-1 — Mounting a YCS 100 (with other units) on a VersaTools rack shelf

1U Universal Rack Shelf

1/2 Rack Width Front False

Faceplate

1/4 Rack Width Front False

Faceplate

Both front false faceplates use 2 screws.

	(2) 4-40 x 3/16"
Use 2 mounting holes on	Screws
opposite corners.

Figure 2-2 — Mounting a YCS 100 on a standard rack shelf

YCS 100 • Installation and Operation 2-3