Electrical connection
!WARNING
ELECTRICAL SHOCK HAZARD
•Disconnect power before making electrical connctions.
•Connect ground wire to green ground screw in terminal box.
•Connect the red wire of the Light cable with the red lead in the hood using a
•Connect the blue blower wire with the blue lead in the hood using a twist- on connector; connect the brown blower wire with the brown lead in the hood using a
•Connect the ligth unit to the ground using one of the following two alter- native ways:
a- Connect the domestic green ground wire under the unused green ground screw belonging to the light unit wiring box using a listed conduit connector.
b- Connect one end of the green ground wire (max lenght 10 yards using 14 awg wire) under the unused green ground screw belonging to the light unit wiring box and the other end under the unused green ground screw belonging to the range hood wiring box.
•Connect the green ground wire (from exterior blower and from power supply cable) under the unused green ground screw.
•Tighten strain relief screws.
•Connect the white wire of the power supply conduit with the white lead in the hood using a
|
| green |
|
|
|
|
| ground |
|
|
|
hood wiring | screw | hood wiring | |||
|
|
|
|
| |
|
|
|
|
| connectors |
|
|
|
|
| blue wiring |
black wiring |
|
|
|
| brown wiring |
|
|
|
|
| |
white wiring |
|
|
|
| exterior |
|
|
|
|
| |
power |
|
|
|
| blower |
|
|
|
| wiring | |
supply | light wiring |
|
|
| |
conduit |
| red wiring |
| ||
|
| purple wiring |
|
•Place the suction panel so that the connection flat wiring for the hood controls passes through the specific opening in the hood body.
•Fix the suction panel to the hood body fastening the screws removed earlier.
•Open the suction cover using the lever provided.
•Connect the flat connection wiring coming from the hood controls with the connector piece placed close to the terminal box. Only in case of the bottom air outlet configuration remove the protection cover from the connector piece on the opposite side of the terminal box.
•Fix the terminal box cover again and fasten the 2 screws removed earlier.
•Replace the metal grease filters in their housings.
•Close the suction panel.
EN |
| 13 |