VER

This command will show you the current software version in your camera.

The camera returns………………...FPGA REV.2.5 The current value may be different

Micro rev. 0.90 Prod rev. A 1.01

SLR

This command allows you to set line rate, enter value and enter.

The range for line rate should be 204 – 38610.

CPO

This command allows you to Calibrate Pixel Offset. You can observe this command by the blinking green/amber LED. When the LED stops blinking, that means that the calibration of the pixels is completed.

You must cover lens when performing this operation!

CPG

This command allows you to Calibrate Pixel Gain. We strongly recommend that this command be done after each CPO. To perform this operation correctly the camera must look at a uniform illuminated light source. The LED will be a blinking amber/red.

VOM

This command reads the different component voltages located within the camera.

The camera returns…………………INPUT = 6.103

3.9VD = 3.225 3.4VS = 3.448 1.5VD = 1.495 1VAD2 = 0.980 1VAD = 0.980

TSB

This command reads the internal camera temperature.

The camera returns…………………Temp 39.42°C (example)

SIT

This command allows you to set the integration time.

Set line rate first (SLR) before using this command.

Enter value plus enter value in microseconds, Range is 20 – 4900.

Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev C• 15 of 42

Page 15
Image 15
Fairchild CAM/CMOS-2K.LS user manual You must cover lens when performing this operation