FEIN Power Tools 9 20 25, 9 20 26, 9 20 24 manual Vacuuming fluids, Vacuuming dry materials

3 41 01 116 06 0.book Seite 11 Freitag, 17. Dezember 2010 12:42 12

			en	11
Vacuuming fluids.	Emptying the container on the Turbo II and
Before vacuuming fluids, always remove	Turbo III (Figure 10):
the paper-dust bag or the textile perma-		➤ Switch the vacuum cleaner off.
nent filter, and check the operation of the	Empty the container after vacuuming fluids.
float.	Afterwards, run the vacuum cleaner with the
When wet vacuuming, the air flow is inter-	accessories connected for several minutes in
rupted by means of a float after reaching the	order to dry them.
maximum filling height. Switch off the vac-		➤ Pull off the protective cap.
uum cleaner immediately, pull the plug from		➤ Pull the lever toward the front to open
the socket outlet and empty the container.		the valve in order to drain the dirty
When foam or water comes out, switch off		water.
the vacuum cleaner immediately and empty		➤ After draining the dirty water, push
the container.		the lever toward the rear again in order
Emptying the container on the Turbo I:		to shut the valve, and reattach the pro-
➤ Switch the vacuum cleaner off.		tective cap.
➤ Open the fasteners on both sides and
		Fig. 10
take off the vacuum cleaner lid.
➤ Empty the container.

Lever Protective cap

Vacuuming dry materials.

For dry vacuuming, insert the filter cartridge in the vacuum cleaner.

For dry vacuuming, additionally use the paper or the textile dust bag.

Empty the container each time after using and remove coarse debris and dust.