GX75.book Seite 12 Freitag, 18. April 2008 11:14 11
us |
| GX 75 |
9. Operating instructions.
| Never touch the running grinding belt. Danger of injury. | |
CAUTION | ||
|
Always use safety glasses. Also use face or dust mask if cutting operation is dusty. Everyday eye- glasses only have impact resistant lenses, they are NOT safety glasses.
Wear appropriate safety clothing. Wear leather safety gloves, arm guards, leather aprons and safety shoes. Wear dust mask and ear protection.
Present the workpiece to the abrasive belt below
the horizontal centerline of the contact wheel. Above the centerline, the workpiece will chatter and it is diffficult to hold, with the possibility the work piece could be pulled away.
Always use an upward stroke to present the work piece to the abrasive belt. This method both improves the cuting and increases safety by drawing hands away from the abrasive belt.
9.1 Switching ON: (Figure 9)
➤Release the emergency OFF pushbutton and lift it up. Press the “I” button.
9.2 Switching OFF: (Figure 9)
➤Lift up the emergency OFF pushbutton. Press the “0” button.
After switching off, the machine runs on for approx. 50 seconds.
9.3 Emergency OFF pushbutton: (Figure 9)
➤In emergency situations, press the red emer- gency OFF pushbutton to switch the machine off.
9.4Changing the speed (Figure 9 – models 2H).
➤ Switch position 1: Low speed
➤ Switch position 2: High speed
Change the speed of the machine only when the machine is at a complete stop with the speed switch.
9.5 Overload protection.
In case of continuous high load over a longer period of time, the machine is switched off. After a
Fig. 9
Emergency OFF pushbutton
12
